I am getting a z-axis overspeed error. The CMM will travel in the z-axis at slow speed for a few inches but then shuts down. It can not travel at all at normal speed.
That may be caused by an overcurrent condition on the Z-axis servo motors.
Maybe the counterbalance pressure needs to be adjusted? Does the problem occur in both directions (up and down) or just when going up?
That may be caused by an overcurrent condition on the Z-axis servo motors. Maybe the counterbalance pressure needs to be adjusted? Does the problem occur in both directions (up and down) or just when going up?
The problem occurs when going up and down. Might have to look into the counterbalance pressure.
same here, z-axis and y-axis motorproblems, had to be replaced.
our programs were running at 300 speed, maybe that was too much with 3 shifts/day.... with the new motors we have reduced the speed to 250
