How / Can You Amend Out Of Tolerance Hole Size in 2022.1

Scenario : For a FAIR you measure a part and a hole diameter is found to have measured out of tolerance.
You measure the hole by an alternative method , is a bore micrometer and find it falls within the tolerance range.
in version 2020R1 you are able to amend the measured value so it falls within the tolerance range.

We have found that in the latest version of 2022.1 you are unable to do this.

Any suggestions going forward as our QM will not accept FAIR with out of tolerance results.

Are we to be stuck using 2020R1 forever??

Parents

Lord_Warfield over 2 years ago

I dont have 2022 but, I was wondering if you were amending your measured value
by changing the nominal and saying yes to "Update measured value"... then changing it back to the correct nominal and saying no to "Update measured value:?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Lord_Warfield over 2 years ago

I dont have 2022 but, I was wondering if you were amending your measured value
by changing the nominal and saying yes to "Update measured value"... then changing it back to the correct nominal and saying no to "Update measured value:?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data