hexagon logo

Removing feature and datum diameters in true position reporting

One my quality engineers has asked me to remove the feature diameter as well as the datum diameters in the true position output on our report. I am using legacy dimensioning for the true position. Two of the datum diameters are using MMC to calculate true position. Is there a way to delete or mask both the feature diameter and the datum diameters from the true position report? I believe they just want to see the X and Y coordinates and the true position in the report.
Parents
  • If you want to utilize datum bonus, I believe those diameters have to be reported.
    You could go the long route and variable everything. Dimension the position like normal. Extract the X, and Y locations, the measured true position value, and calculate your feature bonus all into separate variables. Then, plug those location variables into a generic points measured values. True position that point. The tolerance of the true position would be a variable that adds the position tolerance plus your calculated feature bonus tolerance.

    Or you can just put a comment above each true position saying that all diameters are considered reference.
Reply
  • If you want to utilize datum bonus, I believe those diameters have to be reported.
    You could go the long route and variable everything. Dimension the position like normal. Extract the X, and Y locations, the measured true position value, and calculate your feature bonus all into separate variables. Then, plug those location variables into a generic points measured values. True position that point. The tolerance of the true position would be a variable that adds the position tolerance plus your calculated feature bonus tolerance.

    Or you can just put a comment above each true position saying that all diameters are considered reference.
Children
No Data