One my quality engineers has asked me to remove the feature diameter as well as the datum diameters in the true position output on our report. I am using legacy dimensioning for the true position. Two of the datum diameters are using MMC to calculate true position. Is there a way to delete or mask both the feature diameter and the datum diameters from the true position report? I believe they just want to see the X and Y coordinates and the true position in the report.
I have a feeling that the engineer is going to say not to worry about the MMC bonus, since the MMC on both datums is only +/-.001" and the total true position tolerance is .100". So, I'll just end up deleting the lines that have the datums and the feature itself.
I have a feeling that the engineer is going to say not to worry about the MMC bonus, since the MMC on both datums is only +/-.001" and the total true position tolerance is .100". So, I'll just end up deleting the lines that have the datums and the feature itself.
