Does anyone know if PC-DMIS is able to be ran on a Faro Edge arm with laser scanner? I know it can be ran on Romer, but most of us don't understand Polyworks (which comes with the Faro these days), and I was wondering if the PC-DMIS software was compatible with the Faro Edge arm, and would support a laser scanner?
I have actually used Dezign works and Geomagic for Solidworks with my Quantum S / Laser. both are great for reverse without breaking the bank and they both work within SW. Fowler has a very user friendly Portable software, should look into that. They can run the FARO, not sure about the laser though. I also use Verisurf right now. great software for inspection and reverse. runs my laser just fine.
****Fowler "Fusion" CMM Software can run the FARO scanner.
I have actually used Dezign works and Geomagic for Solidworks with my Quantum S / Laser. both are great for reverse without breaking the bank and they both work within SW. Fowler has a very user friendly Portable software, should look into that. They can run the FARO, not sure about the laser though. I also use Verisurf right now. great software for inspection and reverse. runs my laser just fine.
****Fowler "Fusion" CMM Software can run the FARO scanner.
