hexagon logo

[2022.1 SP3] Problems with tool changer in 2022.1 SP3?

Changing tips on the LSP-X1 works flawlessly, but changing sensors does not work.
When changing sensors, the machine drops the tip off of the LSP like it should, but when it moves to change the sensor to CMMV or CMS, it just parks outside the drop off port for whatever sensor that is loaded and does nothing more?

I have been manually swapping sensors because of this and it does not matter which sensor is loaded and which sensor to load, it parks outside the drop off port and just sits there.
No error message or anything.

If I cancel the execution, the execution status message is "~GCOMM"?

What do I need to do to get the machine to perform the sensor swap?
Parents
  • Appreciate the help!

    Checked the COM settings from an old screendump I had back when the computer needed upgrading and it showed 1200, 7, None, 2. Made sure these were in PC-DMIS as in Device Manager.
    Still didn't work. Changed COM port in PC-DMIS and it started changing sensors - victory! Smiley

    So, now (hopefully) all sensors can be used again, installed 2022.1 SP3, ran full calibration too - now I feel fulfilled!

    Thanks again, fellas!
Reply
  • Appreciate the help!

    Checked the COM settings from an old screendump I had back when the computer needed upgrading and it showed 1200, 7, None, 2. Made sure these were in PC-DMIS as in Device Manager.
    Still didn't work. Changed COM port in PC-DMIS and it started changing sensors - victory! Smiley

    So, now (hopefully) all sensors can be used again, installed 2022.1 SP3, ran full calibration too - now I feel fulfilled!

    Thanks again, fellas!
Children
No Data