Cylinder true position

Using 2022.1, In legacy you can define whether you want the true position of a cylinder at the Start, End, Average or Worst case. Can this be done using Geometric tolerance dialog box?

JacobCheverie over 2 years ago

The Geometric Tolerance will report the position at the worst end of the cylinder as is required by the governing standard (ASME Y14.5 or ISO 1101).
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
NBO CMM over 2 years ago

Thanks, I found out it only reports worst case if you measure height.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel