Hello, when I measured the height (vertical setting - Z axis) of 3.00" gage block, I got 2.999" Then I lay it down horizontally and measured end to end. I got 2.983" Would you please let me know what are the common causes? Thanks.
Hello, after recalibrate the probe, the problem is fixed. I would like to close this post. I do have a new question but I will post it on the new one. Thank all.
Hello, after recalibrate the probe, the problem is fixed. I would like to close this post. I do have a new question but I will post it on the new one. Thank all.
