I am scanning a hexalobe and it is scanning good. The problem is in the report. It doesn't show where the scan is scanning and reporting the part way out. Why don't they match up closer? Here are some pics.
Not sure I follow bob, you say it shows good in the report, are you saying your profile is good, and on the graphics it shows what you you posted? Did you you do an Analysis view of your profile and put that in the report? Not sure what your asking.
Not sure I follow bob, you say it shows good in the report, are you saying your profile is good, and on the graphics it shows what you you posted? Did you you do an Analysis view of your profile and put that in the report? Not sure what your asking.
the picture on the right is after the scan. it is bad. the picture on the left is where it actually scans the part. if I scan with points, the scan pretty much follows the profile but the report shows it is not close.
