Using a loop with differents allignments

Hello everyone!

So I want to write a program for fixture with multiple parts which are the same (3 in total) using loops.
Our customer have parts with their own coordinate system (its a assembly of 9 differents parts).

The problem that I have is:
Every part on a fixture must have their own coordinate system - meaning there should be an offset between them.

Is there a way (probably is) to use a loop with offsetting the coordinate systems which each part.

Thanks.

BR

Parents

constadin over 2 years ago

$$ no,
prepare and save your manual alignments in seperate programs named align1, align2 etc...


Assign/v1=1
v1 =loop/start,id=yes,number=3,start=1,skip=,
offset:xaxis=0,yaxis=0,zaxis=0,angle=0
assign/alignx="align" +v1 +".aln"
recall/alignment,external,alignx
f1 =generic/point,dependent,cartesian,$
nom/xyz,<0,0,0>,$
meas/xyz,<0,0,0>,$
nom/ijk,<0,0,1>,$
meas/ijk,<0,0,1>
dim loc1= location of point f1 units=mm ,$
graph=off text=off mult=10.00 output=both half angle=no
ax nominal +tol -tol meas dev outtol
x 0.0000 0.0500 -0.0500 0.0000 0.0000 0.0000 ----#----
y 0.0000 0.0500 -0.0500 0.0000 0.0000 0.0000 ----#----
z 0.0000 0.0500 -0.0500 0.0000 0.0000 0.0000 ----#----
end of dimension loc1
loop/end

gTilen over 2 years ago in reply to constadin

Thanks for an example.

Going to test it.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

gTilen over 2 years ago in reply to constadin

Thanks for an example.

Going to test it.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data