I have a part with several slots called out. True position of the slot lenght and the width are dimensioned " true position .01 a,b,c for the width in this case .313 wide. Then the same for lenght. .371 long. 2021.2++ software. Programmed auto round slot the true position of the width and the lenght. but the slot lenght .371 comes out as the .313 so it is not adding the radius of each end of the slot in true position..... If I use distance adding radius the lenght of slot comes in correctly, so how do i get it to report the lenght with the radius of slot in true position for Lenght ... thanks
In the GeoTol (or are you using legacy?) dialog, you should have two options, either TP the width or the length of the slot. Make sure you have selected the correct feature for your tolerance.
In the GeoTol (or are you using legacy?) dialog, you should have two options, either TP the width or the length of the slot. Make sure you have selected the correct feature for your tolerance.
