I have a part with several slots called out. True position of the slot lenght and the width are dimensioned " true position .01 a,b,c for the width in this case .313 wide. Then the same for lenght. .371 long. 2021.2++ software. Programmed auto round slot the true position of the width and the lenght. but the slot lenght .371 comes out as the .313 so it is not adding the radius of each end of the slot in true position..... If I use distance adding radius the lenght of slot comes in correctly, so how do i get it to report the lenght with the radius of slot in true position for Lenght ... thanks
i turned off legacy and found the true position of slot length or width as you discribed however it is still showing the slot length.. However it is showing the length as .311/.312 long . program shows it at the .371 long as programmed . i verified with calipers. also reverified my probe diameter is correct. so now how do i get the slot length to show correct? what could i have missed any idea??? Thank you
DATDEF/A,FEATURES=PLN2,,
DATDEF/B,FEATURES=LIN2,,
DATDEF/C,FEATURES=PNT2,,
FCFLOC1 =GEOMETRIC_TOLERANCE/STANDARD=ASME Y14.5,SHOWEXPANDED=YES,
DATUM_MATH=DEFAULT,DISPLAY_COORDS=DRF,
UNITS=IN,OUTPUT=BOTH,ARROWDENSITY=100,
SIZE/NOMINAL=0.371,UPPER TOLERANCE=0.002,LOWER TOLERANCE=0.002,
SLTR12:
UAME SIZE:0.3111,
SEGMENT_1,POSITION,PLANAR,0.01,LENGTH,__,__,A,B,__ ,C,__,
TEXT=OFF,CADGRAPH=OFF,REPORTGRAPH=OFF,MULT=10,
MEASURED:
SLTR12:0.0172,
ADD
FEATURES/SLTR12,,
i turned off legacy and found the true position of slot length or width as you discribed however it is still showing the slot length.. However it is showing the length as .311/.312 long . program shows it at the .371 long as programmed . i verified with calipers. also reverified my probe diameter is correct. so now how do i get the slot length to show correct? what could i have missed any idea??? Thank you
DATDEF/A,FEATURES=PLN2,,
DATDEF/B,FEATURES=LIN2,,
DATDEF/C,FEATURES=PNT2,,
FCFLOC1 =GEOMETRIC_TOLERANCE/STANDARD=ASME Y14.5,SHOWEXPANDED=YES,
DATUM_MATH=DEFAULT,DISPLAY_COORDS=DRF,
UNITS=IN,OUTPUT=BOTH,ARROWDENSITY=100,
SIZE/NOMINAL=0.371,UPPER TOLERANCE=0.002,LOWER TOLERANCE=0.002,
SLTR12:
UAME SIZE:0.3111,
SEGMENT_1,POSITION,PLANAR,0.01,LENGTH,__,__,A,B,__ ,C,__,
TEXT=OFF,CADGRAPH=OFF,REPORTGRAPH=OFF,MULT=10,
MEASURED:
SLTR12:0.0172,
ADD
FEATURES/SLTR12,,
