I have a part with several slots called out. True position of the slot lenght and the width are dimensioned " true position .01 a,b,c for the width in this case .313 wide. Then the same for lenght. .371 long. 2021.2++ software. Programmed auto round slot the true position of the width and the lenght. but the slot lenght .371 comes out as the .313 so it is not adding the radius of each end of the slot in true position..... If I use distance adding radius the lenght of slot comes in correctly, so how do i get it to report the lenght with the radius of slot in true position for Lenght ... thanks
update... instead of auto slot i measured circle and circle.... construct slot... length measured better but still short. measurement .317 long.... could i be dealing with form of the slot causing the incorrect measurement??? calipers show slot length to be about .365 long. slot is short. however, cmm shows slot .317 long as I stated above. This part also has 2 other slots that are .313 wide by .500 long. The cmm is measuring those correctly to hard gage pin and caliper measurements. thanks
update... instead of auto slot i measured circle and circle.... construct slot... length measured better but still short. measurement .317 long.... could i be dealing with form of the slot causing the incorrect measurement??? calipers show slot length to be about .365 long. slot is short. however, cmm shows slot .317 long as I stated above. This part also has 2 other slots that are .313 wide by .500 long. The cmm is measuring those correctly to hard gage pin and caliper measurements. thanks
