Cone & Sphere Intersection Circle

Hello,

I have a part with Cone & Half Sphere on the same axis. The requirement is to extract intersected diameter with Cone & Sphere. While I am trying to construct a circle using these two features with intersection option, PC DMIS displaying math errors. Tried different ways but not succeeded.

Is there any way, we can directly extract intersected circle using Cone & Sphere in PC DMIS?

Parents

vpt.se over 2 years ago

If you can find the intersection point (not necessarily by using a circle) between the cone/sphere, you can create a plane through that point perpendicular to the cone and then intersect the cone with this plane to construct the circle.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Venu KV over 2 years ago in reply to vpt.se

Theo Math Failed. Combination of input features not supported - PC DMIS Error Message.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Venu KV over 2 years ago in reply to vpt.se

Theo Math Failed. Combination of input features not supported - PC DMIS Error Message.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data