I have a Mitutoyo BN1015 with PH20 and UCC T5. Running 2018R1. Will change to angle in DCC program but before it measures drops back to A0B0. Just getting started with programming with this setup. All works fine with A0B0.
Your first angle command has a dash T5: TIP/T1A0B0-T5 and your second angle command has an underscore T5: TIP/T1A15B0_T5
If you're trying to use a variable in your probe change, then that underscore needs to be a minus to be a math function. If both instances are in error, then remove both from the angle command.
Your first angle command has a dash T5: TIP/T1A0B0-T5 and your second angle command has an underscore T5: TIP/T1A15B0_T5
If you're trying to use a variable in your probe change, then that underscore needs to be a minus to be a math function. If both instances are in error, then remove both from the angle command.
