I have a Mitutoyo BN1015 with PH20 and UCC T5. Running 2018R1. Will change to angle in DCC program but before it measures drops back to A0B0. Just getting started with programming with this setup. All works fine with A0B0.
HI, Peter. No I have not. Probe changes to angle with no problem, but just before measuring a point, drops back to A0B0. I can leave it at an angle and measure a manual point, just not in a program.
I started a "case" with Hexagon on Sept 23, no response yet. I've asked several people with (extensive) knowledge of PH20 UCC I++ and PCDMIS. No one has been able to help me.