What's the easiest way to have a flip in a program? The only way I've been able to do it was to have 2 separate programs and then merge them together. I have found its hard to edit the program offline when they are merged together.
STEWY When I flip the part over to measure the backside I put in a message to flip the part over to pause the program. I import the same model but transformed to the position I want. Then do a manual alignment followed by DCC alignment just like you would do on the on a part. HTH
STEWY Check your alignment. Something might be messing you up. When you run the part with seperate programs do you get the same measurement (heights)? Try creating a seperate program with just the alignment and the height. Just to check. HTH
STEWY Check your alignment. Something might be messing you up. When you run the part with seperate programs do you get the same measurement (heights)? Try creating a seperate program with just the alignment and the height. Just to check. HTH