Editing report templete

Is there a way to change what is shown on the default templets? Or even moving the order?

I am trying to measure a customers part that just wants the locations of the holes. So I was able to measure the holes and locations but I am trying to give him the report. I do not need +/- tolerance or even nominal/ bonus etc.. I just want to show what was measured as that is all that is cared about. Can I turn off the rest??

Matthew D. Hoedeman over 1 year ago

It is probably easier to do using legacy reporting (text only report, which you then have to right-click in the report window and mark TEXT ONLY AGAIN to get text-only) of location (NOT position). You can pick what you want displayed for the dimension.

Hit F10 and on the dimension tab, tick/un-tick what you want shown for the dimension.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
FFGOOCH over 1 year ago

ok thank you . I figured it out on the text - only report.

I really like the plain text report but I am guessing it is not possible to do the same to that one.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
constadin over 1 year ago

You could pass the measurements as variables and just give report comments with no dimensions shown whatsoever. That would be funny
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel