I have a callout that is a Position of 0.01 MMC | C | D | with a profile of a line of .005 of an irregular feature (Dovetail). How would you do this to meet the print callout?
Profile of a surface 0.01 | C | D |, Profile of a line 0.005? Any other suggestions?
How is this an invalid use? It is clearly defined in ASME 14.5-2009 and 2018 section 8.8. My problem is how to make PC-Dmis check it. This is a simple overlay/optical comparator check or gage check.
I have found that "usually" when PC-DEMON doesn't allow me to check something the way some "engineer" drew it, it is usually the "engineer" that is incorrect. in this instance, vpt.se is absolutely correct. this is an invalid use.