I have a callout that is a Position of 0.01 MMC | C | D | with a profile of a line of .005 of an irregular feature (Dovetail). How would you do this to meet the print callout?
Profile of a surface 0.01 | C | D |, Profile of a line 0.005? Any other suggestions?
measure a BUNCH of points all along that, make a set out of them, position the set, the align to the set and dimension each point as +/-0.0025 to that alignment
measure a BUNCH of points all along that, make a set out of them, position the set, the align to the set and dimension each point as +/-0.0025 to that alignment