Good afternoon,
How would I go about using Datum A, which is a curved surface to level to? Ais the underside of the part, B is a flat spot on the top side of the part and datum C is a slot on the top of the part.
If you have datum targets, use an iterative alignment. If not, take a good spread of points over the whole surface (enough points to capture the true shape and form) and then do a 3D best-fit.
If you have datum targets, use an iterative alignment. If not, take a good spread of points over the whole surface (enough points to capture the true shape and form) and then do a 3D best-fit.