Good afternoon,
How would I go about using Datum A, which is a curved surface to level to? Ais the underside of the part, B is a flat spot on the top side of the part and datum C is a slot on the top of the part.
Sorry but for me you are not right, because in real life curved surface will touch opposite part in 3 highest places, if it is datum A, it will never touch complete surface
I would make iterative alignment with points choosen by you, then measure whole surface with many points or better scan it and then you will know which ones will be best for datums. If drawing is not complete or clear (what must be) it's up to programmer to choose best way and nobody can say nothing. Or ask designers to add this
I would make iterative alignment with points choosen by you, then measure whole surface with many points or better scan it and then you will know which ones will be best for datums. If drawing is not complete or clear (what must be) it's up to programmer to choose best way and nobody can say nothing. Or ask designers to add this