Good afternoon,
How would I go about using Datum A, which is a curved surface to level to? Ais the underside of the part, B is a flat spot on the top side of the part and datum C is a slot on the top of the part.
Sorry but for me you are not right, because in real life curved surface will touch opposite part in 3 highest places, if it is datum A, it will never touch complete surface
Yes you are right but I did mean same. datum simulator of curved surface is whole countersurface, you can must use at least 3 points to establish datum. But you can use more, best whole surface as I said. But it's up to you how many, what's what i meant.
Yes you are right but I did mean same. datum simulator of curved surface is whole countersurface, you can must use at least 3 points to establish datum. But you can use more, best whole surface as I said. But it's up to you how many, what's what i meant.