Using TP20, 3 way (T-shaped) build. Taking about 50 vector points around a cylinder and constructing a cylinder (least squared). Output cylindricity and it measured 0.0024" yesterday afternoon. Calibrated the probe this morning, re ran the same part and cylindercity measured 0.0011". All the other diameters and distances measured were different by 0.0001"-0.0002".
constadin, I don't have much experience using graphical analysis but i'll play with it. I was thinning of reporting t values of each of the points as a test program.
Hi-Tech Redneck , yes, the part did move out of the CMM and was put back in. We are in the upper 40s low 50s right now.
constadin, I don't have much experience using graphical analysis but i'll play with it. I was thinning of reporting t values of each of the points as a test program.
Hi-Tech Redneck , yes, the part did move out of the CMM and was put back in. We are in the upper 40s low 50s right now.