Using TP20, 3 way (T-shaped) build. Taking about 50 vector points around a cylinder and constructing a cylinder (least squared). Output cylindricity and it measured 0.0024" yesterday afternoon. Calibrated the probe this morning, re ran the same part and cylindercity measured 0.0011". All the other diameters and distances measured were different by 0.0001"-0.0002".
Does your alignment make sure that you hit the same bit of material for each point on the cylinder, or is it just aligned on the cylinder without a clocking feature?
Does your alignment make sure that you hit the same bit of material for each point on the cylinder, or is it just aligned on the cylinder without a clocking feature?