Using TP20, 3 way (T-shaped) build. Taking about 50 vector points around a cylinder and constructing a cylinder (least squared). Output cylindricity and it measured 0.0024" yesterday afternoon. Calibrated the probe this morning, re ran the same part and cylindercity measured 0.0011". All the other diameters and distances measured were different by 0.0001"-0.0002".
Liambo734, I skip the manual alignment and go straight to dcc with those points and then use that cylinder in my alignment. That could be the culprit right there. I use a cylinder that is perpendicular to my problem cylinder for the alignment.
Liambo734, I skip the manual alignment and go straight to dcc with those points and then use that cylinder in my alignment. That could be the culprit right there. I use a cylinder that is perpendicular to my problem cylinder for the alignment.