hello all
my small tip (0.5mm) always measures stuff bigger than it really is. (about .006-0.1mm) even tho i just calibrated it.
it calibration results it get good std, but the the diameter always measures to 0.480 mm.
anyone has any tips & tricks for my small tip?
calibration parameters are almost the same.
for my 0.5mm tip the only difference from the other tips is that i start measuring 10 degrees above the equator not to get shank.
measuremenet speed is the same
Schlag yeah i have program that checks probes against a ring and a sphere, this is where i noticed the small tip always measures the diameter of the ring/sphere to be 0.006 - 0.012mm smaller than the other tips measures it too