hello all
my small tip (0.5mm) always measures stuff bigger than it really is. (about .006-0.1mm) even tho i just calibrated it.
it calibration results it get good std, but the the diameter always measures to 0.480 mm.
anyone has any tips & tricks for my small tip?
What probe system do you have? Any time I use a probe under 1mm, I significantly reduce probe touchspeed.
Depending on probe system that speed can be 1mm/sec for tp200, or 4mm/sec for our HP-S-X1H scanning head.
I would check how square the head is to the machine axes (use a dial indicator and lock 2 axis check in linearly and also see how straight the whole build setup is to a straight edge. If you're calibrating off 10° then it seems something isn't straight IMO