I am trying to pierce the larger highlighted cylinder with the smaller highlighted cylinder and the pierce point ("PNT_F_PIERCE") is showing up on the wrong side of the larger cylinder. Can anyone please explain a simple fix? The small hole is an autocylinder and the large ID is a constructed cylinder from points.
I'm just trying to level (and translate 2 axis) to the large cylinder and then rotate (and translate the remaining axis) to the small hole. Maybe I shouldn't even bother creating a pierce point? I figured that would be more accurate/repeatable than rotating to a short hole, though. Especially because that hole is threaded.
I think it matters which side of the large cylinder is pierced because if the hole was crooked then the constructed point would extrapolate father...
That worked, thank you! Do you agree with this being more accurate than rotating to the hole ittself? I mean I guess it depends what the design intent is.
That worked, thank you! Do you agree with this being more accurate than rotating to the hole ittself? I mean I guess it depends what the design intent is.