"Error PI , S%1 , TR_PI , 0X1200001a Command argument has an invalid value"
Comes up in my prompt and the CMM will not continue calibration. I've read on a few spots to change the acceleration but this has no effect on my error. Please Help
Are you using a scanning probe?
Try cycling the probe balance (top left button on the jogbox)
If that doesn't work, assess if the error is presenting itself in a specific orientation (to determine if the probe sensor has been damaged).
You can do a lower matrix calibration as well to attempt to mitigate the error.
Are you using a scanning probe?
Try cycling the probe balance (top left button on the jogbox)
If that doesn't work, assess if the error is presenting itself in a specific orientation (to determine if the probe sensor has been damaged).
You can do a lower matrix calibration as well to attempt to mitigate the error.
