hexagon logo

i need help with a big part with iterative

Hey guys
so i have this big part, that the datums are defined by 3 datums points (three holes with sample hits that i did iterative with). I then constructed three theorietical planes (alignment planes) and defined those as ABC. Then i measured all the different features on the parted and called them out using FCF position.
the program works well, but some of my results gets weirdly high.
Ill upload pics with the datum targets (see black circles)

Attached Files
Parents
  • Hm, ok. I am leaning more and more towards Matt's solution, because the datum targets are not... well.

    A1B1C1 and A2B2C2 as circles with sample hits on the outside surface.
    Create 3D-line between them and primary alignment in Y-axis (note the is direction is correct according to drawings trihedron).
    Create a midpoint between them, XYZ origin here.
    A3 as circle with sample hits.
    Create offset line between A2B2C2 and A3, the offset value shall be 22.
    Make sure the line is on the left side of A3 when viewing the part in the drawing view (like the left snippet above).
    Secondary alignment in Z using the offset line, around Y.
    Done.

    The drawing is flawed when it comes to datum [C] and the datum target definition. This needs to be adressed to the designer.
  • I assume you are talking about the top two Ø25 E10 since you have aligned on the ABC1 and the ABC2.

    Make sure all your THEO's are correct for the features. Also, if you have a lot welds on the part, some disposition/skewness is expected.
Reply Children
No Data