Just a cmm noob with another question. My company needs me to verify thesize of a polygon (3 sides). We do not have a go/no go pin in yet and they are asking for answers. PCDMIS is showing the Polygon to be larger than nominal and they do not believe my results. (Measured as Auto Polygon) Is there a secondary study I can do to prove the size of a polygon without using Auto Feature and in your experience is Auto feature on a polygon reliable when it comes to measuring Diameters. I would assume I need to do some sort of study and measure from the center of the rads to the Middle of the opposing lines and do some sort of Intersecting points. Using PCdmis 2021.1
@Kai So if i measure 3 lines, make 3 Intersection points and then Midpoints from there I am able to Find my Diameter By constructing a circle from my Midpoints ? Sorry i'm not too familiar with this type of stuff. How do I report Min/max ?
@Kai So if i measure 3 lines, make 3 Intersection points and then Midpoints from there I am able to Find my Diameter By constructing a circle from my Midpoints ? Sorry i'm not too familiar with this type of stuff. How do I report Min/max ?