it does it when I try to "execute block" (load a probe) and it also does it when changing to DCC mode after manual alignment... sometimes the Z axis, sometimes not... plenty of travel left.
i first did a manual aln... got the error msg when i tried to run dcc aln
then closed the program and tested a sister program using the same probes to see if the probes were the issue... they worked fine in the sister program
then i re-opened the original program and recorded the DRO numbers with the cursor at the top of the program... image
Home
then i moved the cursor (but not the probe head) down the program to the man aln... image
Forum
i first did a manual aln... got the error msg when i tried to run dcc aln
then closed the program and tested a sister program using the same probes to see if the probes were the issue... they worked fine in the sister program
then i re-opened the original program and recorded the DRO numbers with the cursor at the top of the program... image
Home
then i moved the cursor (but not the probe head) down the program to the man aln... image
Forum