I seem to be running into a problem with my 2way and 4way checks inside my programs. All of a sudden 2 fixtures in a row are showing an offset on my 4way and 2way 0.5mm in the same direction.
For Example I pick up the tooling balls come back check 2 way and 4way and both fixtures show they are out 0.5 mm in same direction (Machine axis). Does this make any sense ? could it be a bent probe that could be causing this issue ? I'm not sure whats going on here.
Have you calibrated the probe tips and rechecked? That would be strange indeed unless someone smacked the origin tooling ball and didn't inform you. If you're using the same probe angle to check the TB and the datums, that would be even stranger.
Have you calibrated the probe tips and rechecked? That would be strange indeed unless someone smacked the origin tooling ball and didn't inform you. If you're using the same probe angle to check the TB and the datums, that would be even stranger.