I seem to be running into a problem with my 2way and 4way checks inside my programs. All of a sudden 2 fixtures in a row are showing an offset on my 4way and 2way 0.5mm in the same direction.
For Example I pick up the tooling balls come back check 2 way and 4way and both fixtures show they are out 0.5 mm in same direction (Machine axis). Does this make any sense ? could it be a bent probe that could be causing this issue ? I'm not sure whats going on here.
The issue did start after a calibration. I will re calibrate my tips and try again I guess. I cant think of anything else that would be causing an issue like this. Thanks
The issue did start after a calibration. I will re calibrate my tips and try again I guess. I cant think of anything else that would be causing an issue like this. Thanks