I seem to be running into a problem with my 2way and 4way checks inside my programs. All of a sudden 2 fixtures in a row are showing an offset on my 4way and 2way 0.5mm in the same direction.
For Example I pick up the tooling balls come back check 2 way and 4way and both fixtures show they are out 0.5 mm in same direction (Machine axis). Does this make any sense ? could it be a bent probe that could be causing this issue ? I'm not sure whats going on here.
Well, it seems a bit odd that the calibration is only impacting your alignment features. If there were a linear shift calibrated in the probe angle, it should show the same linear shift through all of your program. Did someone mess with an alignment and accidentally save the file?
Well, it seems a bit odd that the calibration is only impacting your alignment features. If there were a linear shift calibrated in the probe angle, it should show the same linear shift through all of your program. Did someone mess with an alignment and accidentally save the file?