I seem to be running into a problem with my 2way and 4way checks inside my programs. All of a sudden 2 fixtures in a row are showing an offset on my 4way and 2way 0.5mm in the same direction.
For Example I pick up the tooling balls come back check 2 way and 4way and both fixtures show they are out 0.5 mm in same direction (Machine axis). Does this make any sense ? could it be a bent probe that could be causing this issue ? I'm not sure whats going on here.
Is it wrong for me to move the part slightly on the fixture 0.5mm so that the 2way and 4way check good and then proceed to run the program? Still not having much luck and they are waiting for numbers,
Is it wrong for me to move the part slightly on the fixture 0.5mm so that the 2way and 4way check good and then proceed to run the program? Still not having much luck and they are waiting for numbers,