Any advice on the best way to measure these ribs on the following part? one side is 35 degrees, and the other side is 40 degrees. Trying to check the centerline of the rib. I have tried taking two points on the rib equal Z and Y and create a midpoint but haven't got the location to show close to tolerance. .150 wide and .030 tall.
Thanks.
If you have a 0.3mm probe it may be possible to create lines on the rib faces and datum B wall then construct intersection points or you could try measuring the rib faces as cones and datum B as cylinder and constructing a circle between cone and cylinder.
Its a tough one to measure given the small size may be better to use optical measuring.
If you have a 0.3mm probe it may be possible to create lines on the rib faces and datum B wall then construct intersection points or you could try measuring the rib faces as cones and datum B as cylinder and constructing a circle between cone and cylinder.
Its a tough one to measure given the small size may be better to use optical measuring.
