hexagon logo

Tip Calibration Process

Hello all, could you please verify that I am calibrating my tips properly! I recently calibrated my machine and my results seem offset in one axis. (Calibration sphere comes off the table after every calibration)

I start by selecting A0B0 only ( Say Yes, Sphere has moved) Calibrate it by itself

Then I Select all tips (Including A0B0) and say No, Sphere has not moved)

The second time I calibrate my tip set should I be including A0B0? Also, Do you guys have a separate probe file called something like "Master probe" with just A0B0? or do you calibrate it within the tip set.

I haven't been on a machine in many years and I'm trying to remember the correct way to do this.

Thanks and my apologies if this is a re-post.
Parents
  • Thanks Louis I will review that. Unfortunately i'm just starting with this company and they have had many crashes and lots of issues over the past 2-3 years. Im pretty sure we just have the one TP20 Module that's still "good". Due to $$$ I doubt ill be able to order any new parts so ill just have to do the best I can with the machine. Thanks for your response.
Reply
  • Thanks Louis I will review that. Unfortunately i'm just starting with this company and they have had many crashes and lots of issues over the past 2-3 years. Im pretty sure we just have the one TP20 Module that's still "good". Due to $$$ I doubt ill be able to order any new parts so ill just have to do the best I can with the machine. Thanks for your response.
Children
No Data