IF you need this automated, I guess you could make your own grid of search points (with a stylus larger than 0.080), and ask PC-DMIS which point was "lowest". Similar to code discussed in this thread:
https://www.pcdmisforum.com/forum/pc-dmis-enterprise-metrology-software/pc-dmis-for-cmms/523659-help-with-min-and-max Then you could use a formula in feature targets to start looking for the hole there. I probably won't have time to test exactly what syntax is needed, but that should steer you in right direction.
IF you need this automated, I guess you could make your own grid of search points (with a stylus larger than 0.080), and ask PC-DMIS which point was "lowest". Similar to code discussed in this thread:
https://www.pcdmisforum.com/forum/pc-dmis-enterprise-metrology-software/pc-dmis-for-cmms/523659-help-with-min-and-max Then you could use a formula in feature targets to start looking for the hole there. I probably won't have time to test exactly what syntax is needed, but that should steer you in right direction.