Autocone measured with line method.
Evaluate straightness works fine, I can select all 4 lines giving me four results in one evaluation.
Autocone measured with concentric circles method.
Evaluate roundness works fine too - but I cannot select all four circles in one evaluation (like the straightness) but must create one evaluation/command for each circle.
The reason for not being able to select multiple circles from within the cone feature is that their diameter differs between them. I believe, that if the circles had the same nominal diameter, it would be possible to select them all in the same roundness evaluation (like cylinders with concentric circles).
The reason for not being able to select multiple circles from within the cone feature is that their diameter differs between them. I believe, that if the circles had the same nominal diameter, it would be possible to select them all in the same roundness evaluation (like cylinders with concentric circles).