Below is a print that I am doing a capability on. Bottom right corner of the print its asking for a 3D angle of 44 degrees and .8 degrees. I'm assuming center of one hole to another. When I try to report it, its giving me a deviation over 1 mm. These Angles should have 0 deviation I would think. Maybe I am doing the angle dimension wrong. Any Help would be greatly appreciated.
You could also set your origin to the rod ID or OD, choose the workplane that matches the print view at bottom right in your snippet and check the polar angle to each hole, if that is what is asked.
You could also set your origin to the rod ID or OD, choose the workplane that matches the print view at bottom right in your snippet and check the polar angle to each hole, if that is what is asked.