I am helping out a bit back on the CMM as a " consultant ( I mainly work in estimating ) and I have been working on a huge lengthy prg. I cannot for the life of me remember the commands that " hide " the code ? Rather than scroll thru the whole prg, you are able to condense it ? Kinds like its in a subfolder ? There was a command at either end of what you want to" hide or show " ? Total brain drain trying to remember....
Correct, the earlier version of PC-DMIS with the Group commands did have issues. I haven't had any issues with the Group commands since 2019 version. Having Groups within Groups could have the potential to cause issues with large routines. I just started to test the Group commands within another Group by highlighting series of Group commands and placing them into one Group. Will have to see if I will get any good results or will I get the Ghost commands like I have in the past as described by louisd.
Correct, the earlier version of PC-DMIS with the Group commands did have issues. I haven't had any issues with the Group commands since 2019 version. Having Groups within Groups could have the potential to cause issues with large routines. I just started to test the Group commands within another Group by highlighting series of Group commands and placing them into one Group. Will have to see if I will get any good results or will I get the Ghost commands like I have in the past as described by louisd.
