I have a datum that is 2 separate plane surfaces with opposing vectors but on the same center line.
What is the best approach: creating a few independent points on both surfaces and combining them into one plane OR creating 2 separate planes and then Constructing a plane from them?
i just performed a quick test using your method and the results using a width are much worse than using a conventional plane made out of points from each surface.
can you comment on your source for using a constructed width is coming from?
for a bit more info i am using this plane to clock, not to level.
i just performed a quick test using your method and the results using a width are much worse than using a conventional plane made out of points from each surface.
can you comment on your source for using a constructed width is coming from?
for a bit more info i am using this plane to clock, not to level.