I have a datum that is 2 separate plane surfaces with opposing vectors but on the same center line.
What is the best approach: creating a few independent points on both surfaces and combining them into one plane OR creating 2 separate planes and then Constructing a plane from them?
Widths are usually fine but depending on the algorithm used, you can run into a lot of issues. I've ran into a lot more fitting errors when using min_circ widths than using Least Squares.
Widths are usually fine but depending on the algorithm used, you can run into a lot of issues. I've ran into a lot more fitting errors when using min_circ widths than using Least Squares.