I have a datum that is 2 separate plane surfaces with opposing vectors but on the same center line.
What is the best approach: creating a few independent points on both surfaces and combining them into one plane OR creating 2 separate planes and then Constructing a plane from them?
That's interesting. I haven't had an issue with using widths yet, even when used to clock, but I'll keep that in mind. I started using widths because I run into a lot of MMB cases and I like that I can dimension it directly as well.
That's interesting. I haven't had an issue with using widths yet, even when used to clock, but I'll keep that in mind. I started using widths because I run into a lot of MMB cases and I like that I can dimension it directly as well.