Hello, quick question here. Does anyone know, If I were to change Nominal modes of a set of Auto Vector points, that have already been created and measured, to "MASTER", will this update all nominals again the next time they are executed? Then the most recent measurements will be nominals?
From the Help file: MASTER
If a point is created when the Mode list is set to MASTER, then the next time the part is measured, PC-DMIS sets the nominal data equal to the measured data. The Mode list is then reset to NOMINALS.
Thanks, yes I read that too. But at the time, my points had already been created and even measured a few times, so I wondered then if I were to change them to MASTER, would it still function the same way.
I tested this the next day, and found that it does still function the same, which is very helpful in some situations.
