I program offline. I have an issue that when I open my programs on the cmm's, my clearplanes and movepoints change, sometimes by many inches! I've actually had it occur on existing programs we've run a hundred times. Has anyone else experienced this? It's a pretty regular occurrence for us.
I don't use clear planes, but I've had move points change from an offline program when executing on the CMM. I just assumed it was because I was updating the alignments when adding read points into programs that previously had manual alignments. I haven't noticed if it's happened in any new programs I've written in 2019 R1 but I'm going to make a note to check next time.
I don't use clear planes, but I've had move points change from an offline program when executing on the CMM. I just assumed it was because I was updating the alignments when adding read points into programs that previously had manual alignments. I haven't noticed if it's happened in any new programs I've written in 2019 R1 but I'm going to make a note to check next time.
