is there a possibility to create an evaluation at the end of a program that shows how many measured points are within, out of tolerance and how many are at 50/75%? In the best case with in the reports.
You can create an analysis view or CAD model view of your deviations if you like.
As far as counting the number of points within a certain range of your tolerance zone...I don't think there is an easy way to do this. I could be wrong though.
You could probably do something like report the "T" value of each point in your scanned set using a loop or Do/until function and do the calculation that way. If using scans, you could probably do something similar while extracting the points individually.
But this seems like over kill when you could report the value and give preferred views.
What is your intent?
You can create an analysis view or CAD model view of your deviations if you like.
As far as counting the number of points within a certain range of your tolerance zone...I don't think there is an easy way to do this. I could be wrong though.
You could probably do something like report the "T" value of each point in your scanned set using a loop or Do/until function and do the calculation that way. If using scans, you could probably do something similar while extracting the points individually.
But this seems like over kill when you could report the value and give preferred views.
What is your intent?
