PC-DMIS

PC-DMIS for CMMs easy way to program Helical pattens

PC-DMIS requires membership for participation - click to join

easy way to program Helical pattens

browningdmis over 1 year ago

I have a cylinder part with 72 holes on the outside. Is there a fast way to program this with all the angle changes and pattern?

Parents

Neil Challinor over 1 year ago

Set your alignment at the centre of the part. Measure the first cylinder around the OD and then use paste with pattern. You'd need an angular step of 23.23° and a Z step of 0.262 applied 74 times.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
browningdmis over 1 year ago in reply to Neil Challinor

This is what I was planning on doing. Will I have to set a probe angle for each of these holes?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

browningdmis over 1 year ago in reply to Neil Challinor

This is what I was planning on doing. Will I have to set a probe angle for each of these holes?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data